The 6 Biggest Plumbing Mistakes You Can Easily Avoid

The plumping process is very important in any home. It ensures there is clean water to the households and also all the sewer drained. Poor plumbing process can lead to devastating effects such as disease encroachment due to poor sewer drainage, and contamination of clean water by pathogens. Some of these plumbing mistakes can be easily avoided. It is therefore always important to consult a plumber Toronto for the best advice. The following are some of the common plumbing mistakes.

1. Connecting pipes that are not similar.

This is one of the common mistakes when it comes to plumbing. Some piping materials cannot be connected together. A good example is copper pipes and galvanized metal pipes. These metals easily corrode since they do not interact together. You can use some other fittings such as brass when connecting to a galvanized metal.

2. Inappropriate slope.

One can make too much or too little slope during the plumbing process. Since liquid moves faster than solid in a steep slope, they will move and leave back solid material. This scenario can cause serious havoc in future. The too little slope may cause material not to move well, and can lead to clogging in the pipes.

3. No traps and vents.

Some traps are not appropriate in some situations. It is not advisable to use S traps in sink drainage. You should ensure that every trap has a vent so that water cannot be siphoned out and leave the trap dry. One should not combine vents before checking the building code. Also, for the basement fixture, they need to have an appropriate vent.

4. The clean-out is in wrong location or amount.

Some plumbers may place clean-out at the wrong location. When clogging has occurred in the line, it is most prudent to conduct adequate clearance before starting any servicing. Some plumbers usually forget this. Depending on the design of the line, one should do the clean out above the first floor.

5. T’s and Y’s are not in the right amount.

One has to calculate the appropriate amount of combination Y inlet, T inlet or 1/8 inch bend that can be stack on the drainage system. Sometimes, the maximum amount of fixture can be exceeded on a stuck and can lead to problems. The plumber has to review the maximum number of a fixture in his/her code book.

6. The space around the toilet is too tight.

There are standard limit ranges that the toilet should be located. They should be 15 inches from the sides of the walls and not less than 18 inches from the wall ahead of the equipment. For the lavatories, they should be more than 18 inches from the wall that is in front.

 

A common mistake in plumbing can lead to devastating effect when not handled properly and in time. It is advisable that the plumber counter checks the line to ensure that no flows are found in the line. The state plumbing code should be referred to from time to time to avert these common mistakes.